During the down time I have been able to work on the bikes a little. Probably a lot more than I should have. One Saturday around lunch I was heading into the shop and I noticed a BMW pulling into the restaurant across the street. I went over and took a look and was surprised to find a 1973 R75/5 in truly beautiful condition. I went in and had a long talk with the owner about his bike while he ate lunch. It turns out that we had met before at Riders Hill, he had been checking out the Special on one of my trips there. Really a cool bike. I would love to cafe one of these.
After he left I went to the shop and cranked the bikes to let them run. The Suzuki was fine but when I cranked the BMW I smelled gas. There was a pretty significant fuel leak under the right throttle body. It was impossible to ascertain the cause with all the fairings on the bike. The BMW was due for a 66,000 mile service so I had a friend help me swap the bikes and put the BMW on the lift. He was not prepared for the weight and let the bike tip over when he was taking it off the center stand. No harm done but I almost had a heart attack. We got it on the lift and I began to work on the bike by removing the fairings. Once that was done I started the bike to evaluate the fuel leak. WTF! Miraculously the fuel leak had disappeared and no amount of wiggling or pulling on the fuel lines could recreate it. I tightened every fuel connection and after several hours threw up my hands. I don't know if I had a clogged injector and a loose fuel line and the tip over unclogged the injector or what but it's not leaking now. I had been having some problems with high speed acceleration and I was wondering if it might be a worn clutch but the clutch seems to be OK and there does not appear to be any oil leaks onto the clutch. Some of the forums have suggested it might be an internal fuel leak in the tank. The last time I rode the bike I smelled fuel at start-up and it ran really ruff but it seemed to straighten itself out. It may have been a loose fuel line connection, but I won't know until I can ride the bike again so I will complete the service.
Stripped down the RT is not a very pretty machine.
I purchased a video inspection scope recently and it was a big help on this project. I needed to turn the rear wheel with the bike in gear to get the motor to top dead center to adjust the valves. I could not use my left arm but this allowed me to go to the other side of the bike, use my right arm. Really cool and it has so many uses.
Over the next several weeks I changed the oil, changed the transmission gear oil, changed the final drive gear oil, replaced the air filter, checked the valves, replaced the spark plugs, repaired a stripped valve cover bolt with a HeliCoil. I had never done this before and it was a little scary to say the least. Taking a drill to the heads on a BMW motorcycle! Really pretty simple.
Drilling out the damaged threads.
Tapping the drilled hole for the HeliCoil.
Inserting the HeliCoil with the insertion tool.
New threads and a perfect repair.
OH yea, heated grips! I figure it will either be late December or early January before I can ride so the heated grips will be nice. My Holiday gift request is a pair of Lee Parks PCI gloves. They have a material inside that is supposed to take the heat from your grips and spread it around your hand. The R1100RT has a cool little feature that allows you to direct the air flowing over the oil cooler onto your hands. I have always thought it would be nice to find a way to direct this air flow into my jacket. Now that would be a heater.
Service and repairs completed.
I took the time to go with a few friends to the AIM Show in Atlanta.
Old classics restored!
The new water cooled R1200GS.
This is the lowered package, my 29 inch inseam can flat foot it!
OOOOOOhhh, what you can get for $18,000!
After the show we had lunch and then went by Blue Moon Cycles in Norcross, GA.
The main level is the sales floor with lots of new and used bikes.
The upstairs area is where the magic is.
Harley Davidson XA. Made for the military during the North Africa Campaign in World War II. Only 42 were made. a Harley with a Boxer engine.
Rare Lambretta Scooter.
This bike was picked in Italy by Frank and Mike on the American Pickers TV Show.
The BMW has what is called floating front disk. The steel disk are mounted to the mounting brackets with 12 aluminum bobbins that allow the disk to move slightly on the horizontal plane white remaining static on the vertical plane. Mine were worn allowing movement on both planes so I replaced them while the bike was in the shop.
Next time I will turn my attention to the special. It has developed a few problems as well, sitting in the shop. How the hell does that happen? All this happened around Thanksgiving. So here's hoping everyone had a great holiday.
No comments:
Post a Comment